www.factorelectronics.com
V-66 SPEAKER INSTALLATION INSTRUCTIONS STEREO MODE
IMPORTANT:
The V-66 amplifiers are capable of driving 4-8 ohm speaker loads in stereo mode and 8ohm loads in bridge mono mode.
Never connect more than two 8ohm speakers wired in parallel to a single amplifier channel in stereo mode. Never connect more than one
8ohm speaker to a single channel in bridge mono mode. Never connect the Left & Right channels of the amplifier together.
Never combine the – negative channels of the amplifier together. Improper speaker installation can damage the amplifiers and void the
warranty. If you are unsure how to connect speakers to the V-66 always contact a qualified Factor Electronics technician before
connecting speakers to the amplifiers.
INSTALLATION:
Connecting 8 ohm speakers to the V-66 in STEREO MODE
Use good quality 12-14awg stranded copper speaker wire. Never run speaker wires parallel to AC wires. If you must cross AC wires
always cross at a 90 degree angle. The speaker output terminal block connectors are removable. Remove the terminal block connector
and make sure that all connections are open by turning each set screw counter clockwise. This insures that the speaker wire opening is
completely open. Trim approx 1/4” of insulation from the speaker wire and twist the copper ends. Insert the speaker wires into the
connector and tighten the set screws. Repeat for the remaining zones.
Right Left Repeat for zones 1-6
- +
- +
4-8ohm speakers
Set the amplifier mode switch to STEREO
