Page
5
with
23
Page
5
with
23
Page
5
with
23
Page
5
with
23
MANUAL - KRAMER Technik MIG / MMA 185
ATTENTION!
Heating test was carried out at ambient temperature and the duty cycle (ratio
Load) at 40
0
C has been appointed by the simulations.
Load) at 40
0
C has been appointed by the simulations.
Load) at 40
0
C has been appointed by the simulations.
The device is designed to carry out welding work in professional conditions
industrial personnel
holding a valid certificate of qualification
compatible
with the applicable standards.
WARNING: This Class A equipment - is not intended for use
in residential locations where electricity is supplied by
system of public low-voltage network. There may be potential difficulties
in ensuring electromagnetic compatibility in those locations, due to
conducted and radiated disturbances.
The device should be used in accordance with the Regulation of the Minister of Economy of
27.04.2000r. on health and safety at work welding (Dz. U. No. 40 item.
470).
The behavior of this manual and following the guidelines set out in the
will enable proper maintenance of equipment in the future. These warnings are intended to
ensure user safety and operation in an environmentally friendly manner.
Before installation and use of the device, read carefully the contents of the entire
instructions.
•
After opening the package, make sure the device has not been damaged during transport.
If in doubt, please contact our service department.
•
Equipment should only use trained employee or consumer.
•
During installation all activities related to electricity should
a qualified electrician.
!
!
Содержание KRAMER MIG/MMA 185
Страница 1: ...ORIGINAL INSTRUCTIONS 2018 MANUAL WELDING...
