Page
17
with
28
Page
17
with
28
Page
17
with
28
Page
17
with
28
MANUAL - KRAMER BI-pulse MIG / MAG 200
10. STORING AND PLAYING PROGRAMS WITH YOUR DEVICE
10. STORING AND PLAYING PROGRAMS WITH YOUR DEVICE
To save or restore user settings from the cache unit, press the buttons (knobs) "A" and "V" to enter the MENU mode.
After setting all welding parameters at the end of the menu will show an option
SAVE
- Save or
LOAD
- open. Using the
After setting all welding parameters at the end of the menu will show an option
SAVE
- Save or
LOAD
- open. Using the
After setting all welding parameters at the end of the menu will show an option
SAVE
- Save or
LOAD
- open. Using the
After setting all welding parameters at the end of the menu will show an option
SAVE
- Save or
LOAD
- open. Using the
After setting all welding parameters at the end of the menu will show an option
SAVE
- Save or
LOAD
- open. Using the
knob "V" must be selected kórmym channel to be stored. Approval of the selection nastąpuję after re-pressing the "V".
To exit the menu at any time by pressing the "V".
11. SYSTEM ERROR CODES
11. SYSTEM ERROR CODES
over temp
- The machine is equipped with protection against overheating. Where the installed sensors too high
over temp
- The machine is equipped with protection against overheating. Where the installed sensors too high
temperature (eg. Fan failure or blocking), the device switches off automatically and the display will show the
message.
over time -
The device is operated in amounts exceeding its rated performance. The message can also occur if you
over time -
The device is operated in amounts exceeding its rated performance. The message can also occur if you
over time -
The device is operated in amounts exceeding its rated performance. The message can also occur if you
use an extension cord with the wrong diameter. After this message appears, turn off the unit for 15 minutes. If after
restarting the still see this message, please contact the service.
Содержание KRAMER 200
Страница 1: ......
