35
Fig. 26
Fig. 27
30÷40 sec.
3÷4 sec.
EN
EXECUTION OF THE SHARPENING
3. Trigger the switch (1) and press the little button (x2);
4. Allow the blade to rotate for about 30 to 40 seconds and then use the switch (2) to
stop it checking with a slight shift (using a pencil) to the outside of the blade if the burr
is formed.
We recommend to perform this check very carefully as
the blade is very sharp.
5. Ascertained the formation of the burr, trigger the switch again (1) for 3/4 seconds
pressing the little buttons at the same time (x2 and x3);
☞
DO NOT PROLONG THIS OPERATION BEYOND THE FEW
ABOVEMENTIONED SECONDS TO PREVENT THAT THE
BLADE EDGE WILL TWIST.
x2
x3
x2
Содержание 2 F250 TC-V
