12.
Locate and remove the nut and washer that retains the stock
lower control arm pivot bolt towards the rear of the vehicle.
Do not remove the bolt, only the nut and washer.
13.
Locate FT20367 driver side shock hoop and place the rear leg
mount over the stock rear lower control arm bolt and attach
with the stock nut and washer. SEE PHOTO ON NEXT
BELOW
14.
Place the front leg of the hoop over the steering box bolt hole
and re-install the stock steering box bolt, nut, and washer.
Torque the steering box bolt to 110lbs and the rear lower
control arm bolt to 90 lbs. SEE PHOTO IN NEXT COLUMN
15.
Pushing on the top of the hoop, mate the upper mounting tabs
to the top of the upper control arm pocket and center punch
holes. Remove the hoop from the truck. Drill out to 3/8”
diameter. Install 3/8” x 1-1/4” bolts, nuts and washers.
Torque to 25 lbs. Drill out to 3/8” diameter. Re-install the
hoop and install 3/8” x 1-1/4” bolts, nuts and washers.
Torque to 25 lbs. SEE PHOTO BELOW
16.
Locate and install Fabtech shock part number FTS7052,
bushings, ½” x 6” bolts, nuts and washers. Torque bolt to
35LBS.
Passenger Side Shown
Driver Side Shown
Driver Side
Shown
Mount hoop bolts with the
nuts on the top of the hoop
