17.
Repeat same procedure for passenger side with these
exceptions.
For Four Wheel Drive Trucks
, remove the
factory differential mounting bolt on the side of the frame
rather than the steering box bolt, torque bolt to 70 LBS.
For
Two Wheel Trucks & Hummer H2,
with the hoop on the
rear lower control arm bolt, rotate the hoop up onto the frame
and mark the hole in the front mount onto the frame. Remove
the hoop from the truck. Using a drill with a 9/16” drill bit,
drill through the entire frame. Then use a 1” drill bit and
ONLY drill through the face of the frame. Locate and install
FT101 Frame Sleeve and the supplied 9/16” hardware.
Follow all other steps the same as the driver side. SEE
PHOTO IN NEXT COLUMN.
18.
Check the front-end alignment and set to the factory
specifications
For 2wd
Trucks &
Hummer H2
Only
Drill 1” hole only
into the face of
the frame and
insert the frame
sleeve
RETORQUE ALL NUTS, BOLTS AND LUGS AFTER 50 MILES AND PERIODICALLY THEREAFTER
.
For technical assistance call: 909-597-7800
