OPTIONAL COMPONENTS:
FTR10004BK/RW Front Bumper w/ overrider & skid plate
FTR10005BK/RW Rear Bumper
FTR10006 Heavy Duty Tie Rod End System
Rhino Long Travel System
FTR10079, FTR10013, FTR10080
2008 Yamaha Rhino
READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION.
CHECK ALL PARTS INCLUDED IN THIS KIT TO THE PARTS LIST ABOVE BEFORE BEGINNING
INSTALLATION OF THIS KIT. IF ANY PARTS ARE MISSING, CONTACT FABTECH AT 909-597-7800.
DO NOT ALTER THE FINISH OF THESE COMPONENTS, EXAMPLE- CHROMING, ZINC PLATING OR
PAINTING. CHANGING THE FINISH CAN CAUSE STRUCTURAL FATIGUE OF COMPONENTS.
DUE TO THE TIGHT TOLERANCES OF THE BUSHINGS, HEIM ENDS, AND UNIBALLS, THE VEHICLE MAY
EXHIBIT A VERY FIRM RIDE IN THE FIRST FEW MILES OF OPERATION. THIS IS NORMAL AND ONCE THE
VEHICLE IS DRIVEN OVER S SHORT PERIOD THESE TIGHT TOLERANCES WILL LOOSEN SLIGHTLY
ALLOWING THE VEHICLE’S SUSPENSION TO OPERATE SMOOTHLY FOR OUTSTANDING PERFORMANCE
PRIOR TO JACKING THE FRONT OF THE RHINO TO START THIS INSTALLATION, MAKE SURE THAT THE
ENTIRE STEERING ASSEMBLY (STEERING WHEEL, RACK & PINION, AND TIE ROD ASSEMBLY)OF THE
RHINO IS CENTERED AND STRAIGHT WITH A FRONT END ALIGNMENT PERFORMED AND RECORDED. DO
NOT INSTALL THIS SYSTEM IF THE VEHICLE ALIGNMENT IS NOT WITHIN FACTORY SPECIFICATIONS.
CHECK FOR FRAME AND SUSPENSION DAMAGE PRIOR TO INSTALLTION.
TO INSTALL THE STEERING ASSEMBLY CORRECTLY, ADJUST THE TIE ROD EXTENSION SO THERE IS AN
EQUAL AMOUNT OF THREADS ON THE 1/2” HEIM AND THE FACTORY INNER TIE ROD END (APPROX. A
½” OF THREADS ABOVE THE JAM NUT). SEE DIAGRAM BELOW
SPANNER WRENCH IS NOT INCLUDED IN THIS KIT.IF NEEDED ORDER FTS98006.
