31.
Locate FTR60138 Front Shock, provided shock mis-
alignments, and the factory shock hardware. Insert the mis-
alignments into the top of the shock and mount into the
stock upper mount with the factory hardware. Insert the mis-
alignments into the heim on the bottom of the shock. Mount
the bottom of the shock to the upper control arm mounts
with the
SUPPLIED
10mm x 1.50 x 60mm bolts and
hardware. (use supplied thread-locking compound) Torque
to 32 LBS. SEE PHOTOS BELOW AND ON NEXT
PAGE. SEE DIAGRAM ON LAST PAGE FOR PROPER
MIS-ALIGNMENT LOCATIONS
32.
Locate FT83179 Front Resi Mount Bracket and FT86013
Hardware kit that is provided with the front shocks.
NOTE:
some 2005 & 2006 model rhinos have a factory locating
hole.
If your Rhino has this locating hole on the front of the
frame section just above where the front upper control arm
mounts to the frame, use a drill with a 5/16” drill bit and
drill out to 5/16”. Locate the supplied 5/16” hardware and
attach the mount to the front of the frame and use a paint
pen or center punch to mark the second hole. Remove the
mount and drill the second hole in to the frame. Re-install
the bracket to the front of the frame and attach with the
supplied 5/16” hardware. If your Rhino
DOES NOT
have
the factory locating hole, position the mount onto the front
of the frame section just above where the front upper control
arm mounts to the frame. With the mount on the front of the
frame, hold the new bracket 3” from the top of the frame
section. Use a paint pen or center punch to mark the two
holes onto the back of the frame. Use a drill with a 5/16”
drill bit and drill out these two holes. Re-install the bracket
to the front of the frame section and attach with the supplied
5/16” hardware. Torque to 20 lbs. SEE PHOTOS IN NEXT
COLUMN
Use new provided
10mm x 60mm
hardware
