Faber Relaxed Premium XL, Руководство пользователя

Страница: 8 / 22

Installation Instructions
7 < < < <
construction with proper insulation and
protection. And ensure respective
distance.

Ensure for great discharge lengths that
the concentric discharge material is
supported every meter, so that the weight
of the material is not supported by the
fire.

It is not permitted to start directly on the
device with concentric cut down pipe
material.
The air supply could then possibly be
closed.
3.4 Terminals
The combined supply and discharge can be done
both via wall or through the roof or through an
existing chimney.

Please note:
Verify if the position of the terminal meets the
local regulations regarding ventilation openings.
For proper functioning, the air supply and
combustion gas discharge are not to be
obstructed. The minimum distances are specified
in Chapter 15.
3.4.1 C
11
, Wall terminal.
For a facade or wall outlet use a wall terminal. (see
Fig. 3.5 C
11
)
Depending on the calculation this can be a
diameter of 130/200mm or 100/150mm.
3.4.2 C
31
, Roof terminal.
For a flat or pits roof outlet use a long roof outlet
with a diameter of 100/150mm (see Fig. 3.5 C
31
)
3.4.3
C
91
,
Existing chimney.
For an existing chimney use the short chimney
outlet with a diameter of 100/150mm (see Fig. 3.5
C
91
).
In this case the existing chimney acts as air inlet an
inserted flexible stainless steel pipe discharges the
flue gas. The top and the bottom should be
airtight.
Depending on the calculated outlet diameter, use a
flexible stainless steel tube of Ø 100mm or Ø
130mm with CE marking for 600°C.

Please note:
The minimum chimney diameter for a 130mm
flexible stainless steel pipe must 200 x 200mm.
And for a 100mm flexible stainless steel pipe
150x150mm.
4 Preparation and installation
instructions
4.1 Gas connection
The gas connection must comply with the
applicable local standards.
We advise using a Ø 15mm gas connection directly
from the gas meter to the appliance, with a shut ‐
off valve in the proximity of the appliance, which
must always be freely accessible.
Position the gas connection so that it is easily
accessible at all times for service, and that the
burner unit can be disassembled.
4.2 Electrical connection
The power supply must comply with the applicable
local standards.
A 6 Volt adapter is used.
For this, a wall socket 230VAC/50Hz must be
installed near the fire.
4.2.1 Faber ITC,
Intelligent Technical Controller
The ITC gives you more options, such as ECO
control, control, error message, maintenance
advice and such.
For further information, see the “ITC” user manual.
Find further information at
www.Faber.nl
4.3 Preparing the fire

Remove the fire from its packaging.
Ensure that the gas supply pipes under
the appliance are not damaged.

Remove frame and glass and take the
packaged parts from the fire.

Store frame and glass in a safe place.

Prepare the gas connection on the
regulator
4.4 Positioning the fire
Take the installation requirements into account
(see Chapter 3).
Place the unit in the right position and set the
height with the leg levellers.
Height adjustment and levelling of the fire (see Fig.
1.9B).
Rough height adjustment:

with the extendable leg, or with the long
legs supplied.