Faber Relaxed Premium XL, Руководство пользователя

Страница: 10 / 22

Installation Instructions
9 < < < <
5 Removing the glass

Remove the mouldings, see Chapter 4.6.6

Place the suction cups on the glass.

Draw the sealing cord from the slot.
(Fig. 2.1).

Slide the glass to the top so that the
bottom is released from the slot. Now pull
the glass out and gradually down.
(Fig. 2.3).
6 Placing the decoration material
It is not permitted to use other or to add more
material in the combustion chamber.
Keep the pilot light always free of decoration
material!
Do not place all decoration material at one time on
the burner; the fabric parts can block it.
6.1 Log set

Place some of the chips on the burner and
on the bottom.

Place the logs as specified. (see Fig. (4.1 of
included log set card)

Divide the rest of the chips on the burner
and on the bottom. Prevent a thick layer
on the burner; this adversely affects the
fire image.
6.2 Glow wire
The “ glow wire ” gives a decorative glow effect.
Pull the wool well apart and place in different
places tufts on the burner.

Please note:
Do not use the glow wire near the pilot
flame!
This can cause a short circuit in the ignition system!
6.3 Pebbles

Place the pebbles on the burner and on
the bottom. (see Fig. 4.2 and 4.3 of
included wood set card). Prevent a double
layer; this adversely affects the fire image.

Replace the glass and check the fire
image.
Start the fire as described in the user manual.
Check if the flame distribution is good. Move the
chips if necessary, until a good flame distribution is
achieved.
7 Checking the installation
7.1 Checking the main burner ignition,
pilot flame
Ignite the fire as described in the user manual.

Check that the pilot flame is well above
the main burner and not covered by chips.

Check the ignition of the main burner on
full and small setting. (ignition must be
smooth and quiet).
7.2 Checking for gas leaks
Check with a gas leak finder or spray all
connections and pipes for gas leakage.
7.3 Checking the burner pressure and
primary pressure
Check that the burner pressure and primary
pressure match the information listed in the
manual, Chapter 14 Technical specifications.
Measuring the primary pressure:

Close the shutoff valve.

Turn measuring nipple B (see Fig. 3.2)
some turns open and connect a measuring
hose to the gas regulator.

Take this measurement at highest setting
of the fire and when the fire is set to pilot
light.

Do not connect the unit if the pressure is
too high.
Measuring the burner pressure:
Check the burner pressure only with
proper primary pressure.

Turn measuring nipple A (see Fig. 3.2)
some turns open and connect a measuring
hose to the gas regulator.

The pressure must correspond to the
value indicated in the technical
specifications of this manual. In case of
deviation contact the manufacturer.

Please note:
Close all pressure measuring nipples and
check for gas leakage.
7.4 Checking the flame image
Let the fire burn for at least 20 minutes at highest
setting and check the flame for:
1. Flame distribution
2. Colour of the flames