Faber Hestia, Руководство по установке

Страница: 13 / 28

> > > > 12
UK IRL
4.4 False Chimney Brest without surround
ƒ
Remove the knock-outs in the DC-box and place vertically the metal studs in the
knock-outs
ƒ
Build the false chimney using Promatect
ƒ
The measure in the clear of the false chimney brest has to be 670x782 (width x
height). These sizes are including the finishing layers
ƒ Check regularly and before the finishing layer if the glass can be replaced
4.5 False chimney with surround
The heater can be installed in a range of positions in relation to the fireplace:
•
The appliance can be installed immediately behind the fireplace (e.g. Jellum
Surround). In this case, the back of the surround is the front of the appliance
•
The appliance can be installed in the Surround (e.g. Wirdum Surround). In this case
has appliance has to protrude 123 mm out of the wall
4.5.1 Preparation of the surround
•
When installing the natural stone fireplace, always make sure that the base is level
(preferably, perfectly horizontal), clean and, above all, stable
•
Carefully remove the fireplace from the wooden crate in which it is delivered
•
Check that all the parts supplied in the crate are complete and undamaged. Lay
them out in a safe place, so that you have a clear idea of what the various parts are
•
As far as possible, measure the dimensions using the drawing of the fireplace (see
Appendix J or K)
•
Smooth the floor using a suitable screed. Be careful with limestone fireplaces, you
may have to seal the hearth or lay plastic sheet underneath to reduce the risk of
staining. Grey cement will stain the natural stone, use only white cement. When
using Knauff (for example, to insert a plate), blistering may occur in some dark
types of natural stone. An alternative is to apply a decelerator to the plaster
•
With a parquet floor, it is advisable to cut away the parquet to the size of the
hearth, less 2 cm (left, right and front). If the parquet has not yet been fitted, you
can place the hearth above it, so that the parquet can be fitted approximately 2
cm underneath
•
We recommend that you first conduct a 'dry run' of the fireplace assembly. Among
other things, this will allow you to see how the various parts fit together
•
It is also recommended that you fit the fireplace first and then, if necessary,
plaster around it
•
If necessary, smooth out the fireplace components using stainless steel washers