Faber Hestia, Руководство по установке

Страница: 12 / 28

11 < < < <
UK IRL
4 Instruction for Installation
4.1 Gas Connection
Installation pipes should be in accordance with BS 6891. Pipe work from the meter to the
appliance must be of adequate size.
The complete installation including the meter must be tested for soundness and purged as
described in the above code.
A means of isolation must be provide in the supply to facilitate servicing. The connection
should be made in 8 mm copper or similar semi flexible tube. (max 1 meter). Ensure that
the gas pipe does not interfere with the removal or replacement of the burner tray or of
the controls. The gas connection is nut and olive suitable for 8 mm pipe.
4.2 Preparing the appliance
Remove the packaging and the pallet under the appliance.
Adjust the total height of the appliance considering the way the appliance will be placed
(see appendix H,J & K). For reasons of transportation the height is pre-adjusted to high.
There are two ways to adjust the height:
ƒ Rough adjustment: by removing the nut and bolt. Shift the leg 30mm and replace
the nut and bolt
ƒ Fine adjustment: by adjusting the couple legs
4.3 Placing the appliance
ƒ
Check paragraph 3.1 before commencing installation
ƒ
If possible, first place the appliance before assembling the flue
ƒ
Check if the floor and wall are sufficiently level and perpendicular. If not, you
should fix this
ƒ
Prepare the gas connection, see paragraph 4.1
ƒ
Position the firebox in the fireplace opening. Make sure that the appliance is level
ƒ
Check the appliance height by moving the control cover drawer. There should be a
clearance of several millimetres (see appendix J & K)between the drawer and the
floor
ƒ
Fasten the appliance to the back wall using the four slidable positioning lips on top
and on either side of the appliance
ƒ
Assemble the flue system onto the firebox (see appendix C)