Faber e-BoX 1000 I, Руководство по установке

Страница: 24 / 56

Installation manual e-BoX 1000/450 I ST
24 < < < <
8 Technical data
9 Troubleshooting and fault codes remote control
230 V 240 V
In
p
u
t
Fi
gu
re
s
Heat 1373 W 1495 W
Flame Only 463 W 504 W
Standby 32 W 35 W
Batteries Remote
(2x) 1,5 AA V
Water Consumption
0,3 L/h
Inlet Water Pressure
0,5-8 Bar
Water Connection
½ or ¾ Inch
Code Symptom Cause Action
The flame effect will not
start. No power supply.
Low water level.
The transducers) are not
connected properly. Check if power supply is connected to
wall socket correctly and the mains
switch is in the ON (I) position. See fig.
3.0-A.
See “First time water fill”, Chapter 4 in
the user manual.
Check that the connector(s) is inserted
correctly, see fig. 3.2.
51 e-BoX will not start or
stopped working and
the LED’s continuously
to blink twice. Low water level.
The absorption valve
(overflow protection) is
activated. See “First time water fill”, chapter 4 in
the user manual.
Switch the mains switch to the “OFF”
(0) position, see fig. 3.0-A. Check all
connections on water leakage and t
urn
the mains switch back in the “ON”
position.
See section 7.2.
56 e-BoX will not operate,
the LED’s continuously
to blink four times. Water filling time is too
long. Press the mains switch to the “OFF” (0)
position, see fig. 3.0-A.
C
heck all connections on water leakage.
Close the ball valves and check the
mesh filter by unscrewing the base of it
to see that it is not clogged with dirt
and debris. Open the ball valves again
and turn the mains switch back in the
“ON” (I) position.