Welder-Generator Operations
1.
Start Hydraulic System.
2.
Allow system to operate for about 5 minutes before engaging welder-generator.
3.
Engage welder-generator
3a.
The red light between the receptacle must be lit bright indicating that the welder rotates
at the proper speed.
4.
Set the range switch to the setting that covers the amperage you wish to weld at.
5.
Set the amperage selector switch to the amperage that is closest to the amperage you want to weld at.
6.
If the amperage is to high set the -10 amp switch to -10 amp side. This will lower the amperage by
10 amps from the amperage selector switch setting.
In order to maintain the set amperage welder must maintain its speed (3600 rpm). The max diameter rod
you can use on this welder is ¼” rod.
Do not change any switch settings during welding. The generator can be used during welding. To get the
6Kw at 120 volts from the generator the range switch must be in the 235-300 position.
The welder and generator are working as soon as the welder reaches the proper RPM (3600).
The generator can be used during welding operation.
9
