FAAC XTR B, Руководство пользователя, Страница: 19 / 24

XTR B 11 3FW#
3
4
5
1
2
1


> 5 s
2

- MASTER - SLAVE
4
6
z
z

< 5 s
®
2 (

¿
) ,
z
® ®
® ®

~ 5 s
8. ADDING TAGS
This procedure allows additional Tags to be enabled
subsequently to the first storage procedure.
You must have a Master Tag that has already been
stored and be close to the reader (without having to
open it). If the XTR B is connected to a BUS-RELAY
interface, use a Master Tag of the required Group.
Tags can be added as either Master or Slave tags.
L
Slave tags cannot be used to enable the
addition of Tags.
ADDING MASTER TAGS
The XTR B must be in standby.
1. Bring a Tag that has NOT been stored up to the
reader and wait for about 5 s:
-
The XTR B will beep twice and flash twice, then
the LEDs will come on steadily.
2. Move the Tag away.
3. Bring the previously stored Master Tag up to the
reader within 10 s.
-
The LEDs still remain steady, the XTR B will
BEEP once.
4. Move the Master Tag away within 5 s.
-
It will flash for 10 s (storing enabled).
5.
Bring the Tags to add up to the reader in se-
quence, within 10 s of each other. The XTR B
beeps once and the LEDs turn on for 1 s for each
Tag added.
6. To finish, let 10 s pass without bringing a new
Tag up to the reader.
- The LEDs turn off: XTR B in standby.
ADDING SLAVE TAGS
Follow the previous procedure but at step
4
, wait
until the XTR B beeps twice before moving the
Master Tag away.
9. MAINTENANCE
Clean the outer surfaces only with a soft cloth Do not
use detergents or oils.
ADDING TAGS
Master Tag already
stored
Tag NOT stored
Tag to add

timeout without Tag:
{
END
... 10 s (

timeout)
...
¿
10 s MAX
¿
10 s (

timeout)
1

+
z
1 s: Tag OK ,
¿
10 s

timeout