![background image](http://html2.mh-extra.com/html/faac/s450/s450_instruction-manual_3065115011.webp)
11
FAAC Model S450H 24V Hydraulic Swing Gate Operator
a
b
4.
MANUAL OPERATION
OPEN
CLOSED
c
UNLOCKED
LOCKED
Fig. 18
5.
ELECTRICAL CONNECTION OF THE ENCODER
The S450H operator is equipped with an encoder system. The proper assignment of the leaf to the corresponding encoder de-
pends on the connection of the two encoder wires (leaf 1- encoder 1; leaf 2 - encoder 2).
THE ENCODER WIRES MUST BE CONNECTED TO THE BUS CONNECTOR OF THE E024U CONTROL BOARD.
To verify the proper combination
LEAF 1 - ENCODER 1 - MOTOR 1
and
LEAF 2 - ENCODER 2 - MOTOR 2
, refer to the LEDs
on the encoders, as shown in Table 2 and Figures 19, 20 and 21.
To invert the leaf-encoder combination, change the encoder polarity by swapping its wires until the right LEDs are lit.
TABLE 3
LED
ON
BLINKING
OFF
DL 1
Power supply ON and BUS - board
communication
Power supply ON but
no BUS communication
(e.g.: cabling fault)
Power supply OFF and no BUS communication
(e.g.: missing or broken connection)
DL 2
Encoder associated to leaf 1
/
Encoder associated to leaf 2
DL 3
/
Pulse reading during leaf movement
Leaf stationary
DL 1: must always be ON
to ensure the right connection between encoder and board.
DL 2: identifies the leaf to which the encoder is installed.
If the encoder is installed on leaf 1, the DL 2 LED is ON.
If the encoder is installed on leaf 2, the DL 2 LED is OFF.
DL 3:
when
blinking
at regular intervals, it signals the pulse reading
during the leaf
movement. When the gate leaf is stationary, DL 3 is OFF.
If the gate is to be operated manually because of a power failure or an automated system fault, activate the release device.
1. Lift the protection lid (Fig. 18, Ref. a) and insert the key in the lock (Fig. 18, Ref. b).
2. Turn the key 90° clockwise to open the cover and lift it.
3. Turn the release knob (Fig. 18, Ref. c) counter-clockwise until it stops.
4. Open or close the leaf manually.
To restore the normal operation of the automated system, perform the above described operations in reverse order.
The model S450H SB is not equipped with a manual release because, thanks to the particular configuration of the
hydraulic distributing flange, you do not need to release the operator to manually move the leaf.
b
The LEDs on the encoder also remain visible when the rear bracket protec
-
tion cover is installed.