FAAC H4, Инструкция по установке и эксплуатации, Страница: 13 / 36

13
If inactive, the control unit will automatically exit from
the ADD DEVICES mode within 5 minutes, and will
remain in
MAINTENANCE PROGRAM mode.
„ „
Exit from the Add Devices mode
When all the elements have been registered:
- press the OFF key of the remote-control or the C
key of the keypad.
The control unit beeps once.
Close the control unit battery compartment last
of all.
AP EFF TEST
Sensors
Remote-control
Control keypad
Telephone transmitter
Siren
Passage open signal
Peripheral units fault /
Telephone line fault
Discharged batteries
System sabotage alarm
Alarm memory-stored / In progress
Maintenance Program mode
Alarm ON / Alarm OFF
2 secs.
REGISTERING DEVICES
The control unit will emit several beep if the
device has not been correctly registered as
regards the radio range limit, or if the maximum
number of elements has been reached.
Movement detector / Opening detector
- Press the detector's TEST push-button.
The control unit sounds a beep and the indicator
light on the detectors' control unit lights up.
SLAVE remote-control
The new remote-control will be a slave remote-
control .
To add a slave remote-control, you have to work in
steps in a limited time period.
Step 1: synchronise the slave remote-control with
the master remote-control. Bring the two remote-
controls forward, so that they touch.
-Simultaneously press push-buttons 1 and 2 on the
master remote-control, and release them when the
indicator light flashes. Press and hold down the ON
key. On the slave remote-control, press the ON key
and release it when the indicator light goes off (after
a double flash, to confirm that a memory-storage
operation has taken place). Release the ON key of
the master remote-control.
-Do likewise for the OFF key
Note: the control unit must be in MAINTENANCE
PROGRAM mode and in ADD DEVICES menu
(yellow indicator light on steady beam).
Step 2: put in ADD DEVICES mode.
- press the ON key of the slave remote-control for
about one second,
- press the ON key again (for about 1 second); you
should hear a beep from the control unit.
- press the OFF key of the slave remote-control for
about one second,
- press the OFF key again (for about 1 second); you
should hear two beeps from the control unit.
Control keypad
- Press the key and then the configuration
access push-button.
The control keypad beeps once. The control unit
beeps once.
Outdoor siren
- Press the TEST push-button of the siren.
The control unit beeps once.
OK OK