FAAC E850S, Инструкция по эксплуатации

Страница: 14 / 20

Kit E850S 14 532181 - Rev.A


42 43
44 45
41
PE N L
PE
N
L
40
J1
1
8
Tr
ansla
tion of the original instruc
tions
ENGLISH
POWER SUPPLY AND GROUNDING
F
Carry out the following operations with the power supply disconnected.
1. Crimp the system earth wire, using the supplied terminal.
2. Install the M5 nut, washer and terminal supplied onto the gear
motor earth connection (
40
-1). Tighten the nut.
3. Connect the phase and neutral wires of the power supply to ter-
minals L and N respectively of J1 (
40
).
5. START-UP
RISKS
PERSONAL PROTECTIVE EQUIPMENT
!
During operation there is a risk of fingers and hands being trapped
between the rack, pinion and cover.
 
If the gate is not engaging a limit switch, any movement following
a start or reset during opening takes place at a slow speed until it
reaches the limit switch.
1. Make sure that the motor and limit switch cables are plugged
into the correct connectors, according to the direction in which
the gate opens.
2. Install the high voltage protection cover on the board E850S and
fasten it in place using the 4 screws that were put aside previously
(
41
).
3. Make sure that the C850 has been released (§ 5.1).
4. Power up the system.
5. Adjust the integrated limit switches (§ 5.2).
6. Programming the E850S board (§ 5.3)
7. Restore automatic operation (§ 5.1).
8. Carry out the procedure for putting the system into service (§ 6).
5.1 MANUAL OPERATION
!
Before performing the release operation, shut off the power supply
to the automation.
During manual operation, gently guide the leaf the whole way. Do not
push it and let it slide freely.
Do not leave the gate with the release engaged: after moving it man-
ually, restore automatic operation.
RELEASE PROCEDURE
1. Turn the lock protection shutter clockwise
2. Insert the release key and rotate it anticlockwise by a quarter of
a turn
3. Turn the release knob clockwise until it stops
RESTORING AUTOMATIC OPERATION
1. Turn the release knob anticlockwise until it stops
2. Turn the release key clockwise until it stops, then remove it
3. Turn the lock protection shutter anticlockwise
4. Manually move the gate until the mechanical system engages.

