FAAC E850S, Инструкция по эксплуатации

Страница: 12 / 20

Kit E850S 12 532181 - Rev.A
L
AMP
L
AMP
230V~
30W
J2
J8
JP1
W
.L.
-
24V
0.2A
J7
34
35
J2
J7
36
37 38
31
U
V W
W V U
MOTOR
OPEN SX
OPEN DX
M
3
32
33
J3 J4
J4
J3
1
Tr
ansla
tion of the original instruc
tions
ENGLISH
ELECTRIC MOTOR
1. Make a hole in the cable gland seal. Insert the electric motor
cable into the cable gland seal (
31
-1).
2. Remove the three-pole terminal from J3 or J4.
3. Connect the wires of the motor to the three-pole terminal follow-
ing the colours indicated in
31
.
4. Plug the wired three-pole terminal wired into:
- J3 if the gate opens towards the left
- J4 if the gate opens towards the right
 
The direction in which the gate opens refers to when looking at the
gate while standing in front of the C850.
FLASHING LIGHT
Insert the cable of the flashing light into the cable gland seal indicated
in
33
. Connect the flashing light (230 V~, max 30 W model), to
the LAMP terminals of J2 (
34
).
COOLING FAN
The board cooling fan is connected at the factory to J8 (
35
).
The fan is powered by a DC voltage. The connection is therefore
polarised.
The fan is started and stopped by the board according to the temper-
ature of the component to be cooled.
RADIO RECEIVER/DECODER BOARD
The quick insertion connector JP1 is specifically for 5-pin FAAC radio
or decoder boards.
It is a polarised type of connector (
36
).
 
If a FAAC model RP receiver is used, it is recommended to install the
appropriate external antenna in order to obtain a sufficient range.
LED
The LED remotely indicates the status of the gate as follows:
gate status LED status
closed off
opening on
open on
closing flashing
Insert the cable of the LED into the cable gland seal indicated in
37
. Connect the LED (model 24 V
"
, maximum 0.2 A) to the
W.L. and - terminals of J7 (
38
).
ACCESSORIES POWER SUPPLY
The E850S supplies 24 V
"
max. 0.5 A for the connected accessories,
on the +24V and - terminals of J7 ().
BROWN BL
UE
GREY/BLA
C
K