FAAC E124, Быстрый старт

Страница: 6 / 12

Page | 5
Verification of BUS 2easy Connections on J10 Terminal
E124 Control Board Programming
Basic Programming and Time Learning (Setup)
The function is
displayed only while
the button is pressed
For simple programming of the motor type and logic only Basic Programming is required as below. The first parameter that
MUST be set is the “CF”. This will then allow correct configuration to proceed. Please note that until SETUP as been completed
the display will show a flashing “50”, which is SETUP requested.
The J3 Terminal on the E124 Control Board has two diagnostic LED’s (DL15 – Red and DL14 – Green). These LED’s assist in
ensuring that any devices connected on the FAAC BUS 2easy network are installed correctly.
Programming is split over two levels:
 Basic Programming
 Advanced Programming