![background image](http://html1.mh-extra.com/html/faac/e045s/e045s_user-manual_3113898017.webp)
E045S
15
532373 - Rev.A
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
■
AP
AUTOMATIC STEP-BY-STEP
This logic only uses the OPEN command.
OPEN if the automation is closed, causes it to
open. The automation closes automatically after the
pause time has elapsed.
OPEN during pause, stops the gate and the next
OPEN command closes it.
OPEN during opening, stops the gate and the next
OPEN command closes it.
OPEN during closing, causes it to reopen.
The triggering of the closing photocells: during pause,
reloads the pause time.
■
b
SEMI-AUTOMATIC b
This logic uses the OPEN A commands to open and OPEN B (CLOSE)
to close. Partial motion is not available.
OPEN if the automation is closed, causes it to open.
OPEN during closing, causes it to reopen.
If the photocells are triggered: the direction of move-
ment is reversed.
■
C
DEAD-MAN
This logic uses the maintained commands OPEN A (OPEN) to open
and OPEN B (CLOSE) to close. Partial motion is not available.
!
A maintained command must be activated intention-
ally and the automation must be visible.
Maintained OPEN opens the automation.
Maintained CLOSE closes the automation.
If the photocells are triggered: movement is stopped.
6.4 SETUP
The SETUP procedure consists of a series of movements
during which the board acquires the length of travel
and other leaf parameters. The SETUP procedure also
registers the BUS 2easy devices that are present.
SETUP needs to be carried out:
-
when
S0
flashes on the display (e.g. when the
automation is first put into operation)
-
after a board has been replaced
-
if you wish to modify the length of travel of the
leaves
-
if there are active errors that require the SETUP
procedure to be carried out
-
if programming functions are modified that require
a new SETUP
Checks prior to SETUP:
-
the automation must not be set to manual mode
-
the STOP input, if not used, must be bridged
-
make sure that the settings of the following func-
tions in Basic Programming are correct:
Mn
number of motors
En
encoder (has to be enabled, if present)
!
While the SETUP procedure is being carried out,
prevent transit in the area of movement of the leaves
because the safety devices are disabled.
1. Go to the
tl
function in basic programming. The
value displayed is
--
.
The leaves must be closed. To close them now,
press the
++
button for Leaf1 and the
--
button
for Leaf2.
2. Press the
++
and
--
buttons simultaneously for a
few seconds.
The display flashes, then the first movement starts
and
S1
appears on the display.
Release the buttons.
3. SETUP starts. The display indicates the current phases
with a flashing code (from
S1
to
S4
, see
SETUP
phases).
If the SETUP procedure doesn’t start or stops before it
has been completed, the board exits from program-
ming mode and
S0
flashes on the display: check the
ERRORS that are present (§ Diagnostics).