![background image](http://html1.mh-extra.com/html/faac/daab-ep105/daab-ep105_instruction-manual_3113213014.webp)
INSTRUCTION MANUAL DAAB AUTOMATIC CONTROL UNIT EP105
14
Revision 3
Configuring the EP105
This section provides general instructions on how to change settings in the EP105.
Remember to discharge any static charge in your body by always touching an earthed connection before starting installation.
• General
All values are stored according to a list of channels (in the channel reference), with each channel corresponding to a particular
control parameter or value in the EP105.
The display can show a value up to four digits long, or a channel number with the prefix C, d, F, L, o, P or r, followed by three
digits.
The display can be used to show values as well as change settings – the value flashes while the setting is being changed.
If E appears followed by a number, this is an error message – see "Error messages". Note that the startup values
"EP-1" and "EP-2" are not error messages. When the power is connected, EP-1 appears when the unit controls one motor,
and EP-2 when the unit controls two motors.
The <
┘
button switches between the value and the channel number and, in configuration mode, it saves the value.
The + button scrolls up the channel list in channel mode. In configuration mode, the button increases the value.
The - button scrolls down the channel list in channel mode. In configuration mode, the button reduces the value.
If no button is pressed in 90 seconds, the display switches to economy mode with reduced brightness. Press any button to
return to normal mode.
Display
Description
C
nnn
Channel number for the EP105
d
nnn
Channel number for the vehicle
detector
F
nnn
Channel number for the frequency
converter
L
nnn
Channel number for the limit switch
o
nnn
Channel number for the output card
P
nnn
Channel number for programmable
inputs
r
nnn
Channel number for the wireless card
E
nnn
Error message (not EP-1 and EP-2)
n
nnn
Message
nnnn (flashing)
The channel value is changed but not
saved
Button
Description
+
Button to increase the channel or value
-
Button to decrease the channel or
value
<
┘
Switch between channel number and
value
<
┘
Save/confirm the changed value
Switch between different channel
groups
• Readout of parameters in the EP105
Press the <
┘
button so the display shows the channel number – a letter followed by digits.
Press the button to quickly change between letters (channel groups).
Press the + or - button to step to the channel number you want.
Press the <
┘
to show the value on the display.
Press the <
┘
button again to exit and return to the channel number. Leave the unit in this mode – you cannot exit any further.
• Setting parameters in the EP105
Select the channel number according to the readout above.
Press the + or – button. The value starts flashing and is ready to be changed. Return to the original value by pressing the
button.
Press the + or - button to step to the value you want.
Press the <
┘
button to save the value.
Press the <
┘
button again to exit and return to the channel number. Leave the unit in this mode – you cannot exit any further.
Содержание DAAB EP105
Страница 1: ...INSTRUCTION MANUAL DAAB AUTOMATIC CONTROL UNIT EP105...
Страница 58: ...INSTRUCTION MANUAL DAAB AUTOMATIC CONTROL UNIT EP105 58 Revision 3 Notes...
Страница 59: ...INSTRUCTION MANUAL DAAB AUTOMATIC CONTROL UNIT EP105 59 Revision 3 Notes...
Страница 60: ...Revision 3 FAAC Nordic AB Box 125 SE 284 22 Perstorp 46 435 77 95 00 www faac se support faac se...