10
FAAC 400 Hydraulic Swing Gate Operator
Opening
Angle
a
(inches)
b
(inches)
s
(inches)
d(**)
(inches)
c(*)
(inches)
90°
4
3
1/2
0
2
7
1/2
90°
4
5/16
4
0
2
3/8
8
1/4
90°
4
3/4
4
5/16
0
2
3/4
9
90°
5
1/8
4
3/4
0
3
1/8
9
7/8
Refer to Table 1 for this particular application. Select the
operator according to leaf length as detailed in Table 1.
Installation dimensions are provided in Table C.
To adjust the anti-crushing system for outward opening
gates only, perform the following steps (note that these
steps differ somewhat from instructions provided in
Section 4.1):
•
OPEN screw (green wording): gate closing direction.
•
CLOSE screw (red wording): gate opening direction.
•
To reduce torque, turn screws counter-clockwise.
•
To increase torque, turn screws clockwise.
When you have finished installing the unit, run a
functional check of the automated system and all ac-
cessories connected to it, especially safety devices.
Explain to the client the correct operation and use of
the operator and indicate potentially dangerous areas
of the automated system.
(*) Rod effective stroke (**) maximum dimension
Figure 17
Table C: Standard Operators Recommended Dimensions
If the gate has to be moved manually due to a power
failure or a fault in the system, use the release device
as described below.
•
Lift the protective plug (Fig. 16, Ref. 1) and insert
the supplied key (Fig. 16, Ref. 2).
•
Turn the key 90°clockwise to open the cover.
•
Lift the cover (Fig. 16, Ref.3).
•
Turn the release knob counter-clockwise approxi-
mately two complete turns (Fig. 16, Ref. 4).
You can now open or close the leaf manually.
7. MANUAL OPERATION
8. RESTORING NORMAL OPERATING
MODE
To prevent an involuntary pulse from activating the
operator during manual operation, cut power to the
system before re-locking the operator.
•
To re-lock the operator, turn the release knob
clockwise until it stops (Fig. 16, Ref. 4).
•
Close the cover and turn the key 90° counter-
clockwise (Fig. 16, Ref. 2).
•
Finally, remove the key and close the protective
plug (Fig. 16, Ref. 1).
9. SPECIAL APPLICATIONS FOR SWING
LEAF GATES
Opening Outward, with Operator Installed
Inside
6. SYSTEM TEST
Figure 16
Содержание 400
Страница 2: ......
Страница 29: ...27 FAAC 400 Hydraulic Swing Gate Operator 15 PREWIRED ENCLOSURE DIAGRAM ...