F5 WANJet 500, Руководство по платформе

Страница: 28 / 77

Chapter 2
2 - 6
Configuring the addresses
After the WANJet platform is powered on and started up, you need to do
some minimal configuration, such as entering the WANJet appliance IP
address, its subnet mask, and default gateway. You can configure the
addresses in one of two ways:
• Set the addresses using the four-key LCD keypad.
• Set the addresses using the config command from a serial console or PC.
The advantage of using the LCD keypad is that you do not have to connect
another computer to the platform. When you finish the initial configuration
on the LCD, you can log in to the Web UI from your computer as you
normally would to manage the device.
The advantage of using a serial console or PC is that the configuration is
easier from the command line than it is using arrow keys on the LCD
keypad. Connecting the console or PC is easy, and a few additional
commands are available from the command line.
It is up to you which method you prefer. The following procedures describe
both methods. The procedure on using the LCD describes minimal
configuration only. For details on the using the LCD, see
Operating the
LCD panel , on page 3-1. If you want to use the config command, skip to To
set the addresses using a serial console or PC , on page 2-7.
To set the addresses using the LCD keypad
1. Locate the LCD display on the front of the WANJet 500 platform. It
should show the default IP address.
2. On the LCD keypad, press
X
.
The LCD displays Menu , followed by >Admin .
3. Press
X
.
The LCD displays Admin , followed by > Configure .
4. Press
X
.
The LCD displays Configure , followed by > IP Address .
5. Set the WANJet 500 IP address:
a) Press
X
to display the IP address (default: 192.168.168.100 ).
b) Press
X
to move from digit to digit in the address, and use
S
and
T
to set the numbers in the address.
c) With the cursor on the last number on the right, press
X
.
The LCD displays Configure , followed by > IP Address .