F5 Viprion, Руководство пользователя

Страница: 18 / 74

alert BIGIP_MCPD_MCPDERR_POOL_MEMBER_MON_UP "Pool member (.*?):(.*?) monitor status up."
{
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.11"
}
alert BIGIP_MCPD_MCPDERR_NODE_ADDRESS_MON_UP "Node (.*?) monitor status up."
{
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.13"
}
5. Save the file and exit the text editor.
The front panel LEDs now indicate when a node is down.
Additional indicator LED status conditions
A few LED status conditions are not covered in the definition tables in the
/etc/alertd/alert.conf
file.
Yellow intermittent Status LED indicator
A yellow intermittent Status LED indicates that the unit is not under host computer control. This might be due to the
host being halted or due to a software or hardware problem that interferes with the host’s control of the LED.
Green/Yellow solid Status LED indicator
When the Status LED indicator is solid yellow or green, it indicates that the VIPRION system is in a Standby state
(yellow) or an Active state (green). It displays solid green if the unit is Standalone or if it is the Active unit of a redundant
system configuration. It displays yellow if the unit is the Standby member of a redundant system configuration.
Platform Interfaces
You can perform configuration tasks such as displaying interface status and settings and setting the media type using
the Traffic Management Shell (tmsh).
When using the tmsh
interface
command, you can either apply the command to all interfaces or to a specific interface
key.
About blade interfaces
The blades have SFP connector optic interfaces, RJ45 10/100/1000 copper interfaces, and 10GbE XFP or 10GbE SFP+
optic interfaces that are connected internally. Each set of interfaces is numbered from x.1 through x.n, with each group
of media types designated by a different prefix. It is important to note some facts about these interfaces:
• The RJ45 connectors can each support 10/100/1000 Mbit Ethernet speed, except where otherwise noted.
• The SFP connectors can each support 1000 Mbit speed with a 1 GbE optic module installed or 10/100/1000Mbit
speeds with an F5-branded copper SFP module.
• The XFP connectors can each support 10G speed with an F5-branded copper XFP module optic module installed.
• The SFP+ connectors can each support 10G speed with a F5-branded optic SFP+ module or 1000 Mbit speed with
a F5-branded optic SFP 1GbE module optic module installed.
Viewing the status of a specific interface
You can use tmsh (or bigpipe) to view the status of a specific interface on a platform.
1. From the system prompt, type the following to open tmsh:
tmsh
18 | Platform Guide: VIPRION | The VIPRION platform