F5 6900, Руководство по платформе

Страница: 43 / 126

Using Additional 6900/8900 Platform Functionality
Platform Guide: 6900 and 8900 4 - 3
To configure indicator LEDs to display node status
1. From the command line interface, type the following command:
cd /config
2. Using a text editor, such as vi or pico , open the user_alert.conf file.
3. Add the lines shown in Figure 4.1 to the end of the file.
4. Save the file and exit the text editor.
The front panel LEDs now indicate when nodes are marked down.
Specific status indicated by the indicator LEDs
This section includes some specific conditions that are not covered in the
definition tables in the
/etc/alertd/alert.conf file.
Yellow intermittent status indicator LED
A yellow intermittent status LED indicates that the system is not under host
computer control. This might be due to the host being halted or due to a
software or hardware problem that interferes with the host’s control of the
LED.
Green/Yellow solid status indicator LED
When the status indicator LED is solid yellow or green, it indicates that the
BIG-IP system is in a Standby state (yellow) or an Active state (green). It
displays solid green if the system is standalone or if it is the active system of
a redundant system configuration. It displays yellow if the system is the
standby member of a redundant system configuration.
alert BIGIP_MCPD_MCPDERR_POOL_MEMBER_MON_DOWN "Pool member (.*?):(.*?) monitor status
down." {
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.10";
lcdwarn description="Node down" priority="1"
}
alert BIGIP_MCPD_MCPDERR_NODE_ADDRESS_MON_DOWN "Node (.*?) monitor status down." {
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.12";
lcdwarn description="Node address down" priority="1"
}
alert BIGIP_MCPD_MCPDERR_POOL_MEMBER_MON_UP "Pool member (.*?):(.*?) monitor status up."
{
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.11"
}
alert BIGIP_MCPD_MCPDERR_NODE_ADDRESS_MON_UP "Node (.*?) monitor status up." {
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.13"
}
Figure 4.1 The user_alert.conf file