Power Jumpstarter PJ125 19
EN
•
Do not use the compressor for more than 6 mi-
nutes. Then allow it to cool down for approx. 10
minutes. Overheating and permanent damage
may otherwise occur.
•
Please also note the operating instructions of
connected devices.
Special no
t
e
s
•
Do not inflate objects beyond the intended or
specified pressure. The object could burst.
•
Never inflate larger objects such as lorry or
tractor tyres, air mattresses or rubber boats.
This exceeds the delivery rate, thus the run-
time of the compressor.
•
The pressure specifications of the manometer
are reference values. Check the pressure with a
calibrated air gauge.
•
The max. pressure of 150 PSI (10.3 bar) will
only be reached if the pump volume is not
greater than 0.5 L.
Produ
c t
Over-
view
1. „12V“ button
2. „USB“ button
3. Carrying handle
4. Display
5. LEDs
6. Light button
7. „220V“ button
8. USB port
9. „-“ button
10. „+“ button
11. „MENU“ button
12. 12 V car socket
13. „JUMP START“ dial
14. Storage compartment
15. Compressor On/Off switch
16. Charging LED, green
17. Mains socket
18. 230 V socket
19. Fuse
20. Red cable with clamp (+)
21. Black cable with clamp (-)
22. High-pressure hose
23. Valve quick coupling
24. Valve for inflatable toys
25. Valve for inflatable toys
26. Valve for sports balls
Ri
s
k of chemi
c
al burn
s
!
•
Risk of eye injuries. Wear safety goggles and do
not lean over the battery. The electrolyte of the
drained starter battery will still be liquid in low
temperatures.
Ri
s
k of ele
ct
ri
c
al
s
hock!
Failure to follow all instructions listed below may
result in electric shock, fire, serious injury and
damage to property.
•
Never use the cable to carry or pull the device.
•
Only unplug the cable from the outlet by the
plug. The cable could be damaged.
•
Do not use device if damaged. Damage to the
device or the charging cable increases the risk
of electrical shock.
•
Route the electrical cable so that it is not
possible to trip over them and to prevent them
being damaged.
•
Maintenance work must be done by qualified
electricians.
•
Avoid pouring or dripping water or other liquids
over it. If water penetrates electrical devices,
the risk of electric shock increases.
•
Ensure that all plugs and cables are free of
moisture. Never connect the device to the
mains with wet or moist hands.
•
Only connect 230 V devices with permitted
power plugs.
•
Never create a short circuit or bridge on the
inputs and outputs of the power inverter using
foreign objects.
•
Do not attempt to disassemble or repair the
device. Immediately have the device repaired or
replaced by a specialty shop if defective.
•
Do not cover the device as it may be damaged
from extreme heating.
•
Immediately stop using the device if you notice
smoke or an unusual odour.
•
Do not allow the clamps involved to touch.
•
Never allow the contacts of the lead connected
to the battery’s positive terminal to come into
contact with electrically conductive vehicle
parts.
•
The vehicle bodies must not come into contact.
Ri
s
k of injury!
•
Do not modify or manipulate the product as
this will increase the risk of injury.
•
The high-pressure hose becomes hot during
use. Therefore allow it to cool down before
touching it and rolling it up.
