TRT800A / P/N 800ATC-A-(2xx)-(3xx)
Operation and Installation
36
Document-No: 03.2114.010.71e / Revision: 2.00
The check for correspondence between the primary altimeter and the
TRT800A is usually performed every 24 months as part of the aircraft's
altimeter checks.
Altitude correction is based on setup configurable offset values at five
interpolation points ( 2000, 10000, 18000, 25000 and 35000 ft). The
offset value itself is limited to a range from -100 to + 100ft at each point
(10ft steps).
4.5
Setup Procedure
Programming of the ICAOA 24-bit Aircraft Address and of
the Aircraft Category shall be executed by qualified
personnel only!
A wrong Aircraft Address or Flight ID may cause serious
problems ATC or with ACAS/TCAS systems!
Pilot and owner are responsible for correctly set
transponder data.
4.5.1
Setup Menu Control
In order to access the functions described in the following paragraphs
push and hold
in Standby mode. Release
if desired counter
value/ menu name is displayed to enter the menu. The following menu
entries are selectable:
Count Displayed Name
Function
0..3
FID
FID is displayed
4..8
CHANGE FID
Enter FID setup page
9..13
SHOW SETUP
Enter setup summary listed on different
pages (no changes possible)
25..28 ENTER SETUP
Enter transponder general configuration
pages
31..34 ALTITUDE
CORRECTION
Enter altitude correction menu
