TRT800A / P/N 800ATC-A-(2xx)-(3xx)
Operation and Installation
24
Document-No: 03.2114.010.71e / Revision: 2.00
3.9
Post-Installation Check
All steering and control functions of the aircraft are to be examined, in
order to exclude disturbances by the wiring.
The most important factor in the transponder configuration is the setting
of the ICAO address (see section 4.5.4).
3.10
Starting Up
Turn the transponder on with
.
After start-up the following screens appear:
Attenuation from antenna to transponder at 1090 MHz must
not exceed 1.5 dB!
A certified maintenance shop must verify proper operation of
the transponder by testing in accordance with Appendix F of
“14 CFR Part 43– ATC Transponder Tests and Inspections”.
The TRT800A starts in Standby Mode (indicated with
STBY). In order to change into operational mode (indicated
with ACS) press
. If ground switch is connected and
status “in flight” is selected TRT800A starts in active mode.
Very important is the correct configuration of the 24bit
Aircraft-Address (see 4.5.4 General Setup).
TRT800A
V5.3
FPGA-Vers: 102
2000
FL 030
STBY
7000
