F.F. Group GPG 10600TE HD, Оригинальное руководство пользователя

Страница: 14 / 80

| English 14
4. Clean the inside of the air filter case and cov -
er from dirt with a soft cloth. If the engine is
equipped with an oil bath type air filter, replace
the oil with new engine oil.
5. Reinstall the air filter element and follow the
reverse procedure to put back in position the air
filter cover.
WARNING
Never clean the air filter with flammable or low flash-
point detergents to avoid the risk of a fire or explosion.
NOTE
If the engine frequently works under dusty or other se-
vere circumstances, clean the air filter every 10 hours
and add change its oil with new. If necessary, change
the air filter element every 25 hours.
SPARK PLUG
To maintain the spark plug (Fig. 9.4):
1. Remove the spark plug cap (Fig. 9.1) to access the
spark plug (Fig. 9.2).
2. Use an appropriate spark plug tool (Fig. 9.3) to
carefully remove the spark plug.
3. Inspect the condition of the spark plug and its
electrode. It must be clean and not worn. Check
that the spark plug gap is between 0.7 and
0.8mm. Replace the spark plug with a new one,
if needed.
4. Carefully thread the spark plug into the engine by
hand.
5. Once threaded, use the appropriate spark plug
tool to tighten the spark plug, paying attention
not to use excessive force damaging the threads.
6. Re-attach the spark plug cap.
WARNING
Never allow dirt or debris to enter the cylinder bore.
Before removing the spark plug, thoroughly clean the
spark plug and cylinder head area.
FUEL SEDIMENT CUP
WARNING
Maintain the fuel carburetor only outdoors and in
well ventilated areas.
To maintain the fuel sediment cup:
1. Turn the fuel valve to the “OFF” position (Fig.
10.1).
2. Remove the carburetor fuel sediment cup (Fig.
10.1) with its rubber seal ring (Fig. 10.1).
3. Wash the removed parts in solvent, dry them
thoroughly.
WARNING
Never clean the fuel sediment cup with flamma ble or
low flash-point detergents to avoid the risk of a fire or
explosion.
4. Replace the rubber seal ring with a new one if
needed.
5. Reinstall the rubber seal ring and sediment cup
and secure in position.
6. Turn the fuel valve to “ON” position and check for
any fuel leaks.
FUEL FILTER
The fuel tank may be fitted with a filter, depending
on tiller model, situated at the fuel tank cap. The fuel
filter can be picked out and should be checked pe -
riodically. If the filter is dirty, clean it and replace it
with a new one when required. In case the inside of
the fuel tank is dirty, it can be cleaned by rinsing the
fuel tank with clean petrol.
CLEANING
Use a small soft brush to clean the outside of the
unit. Do not use strong detergents. Household
cleaners that contain aromatic oils such as pine and
lemon and solvents such as kerosene can damage
plastic housing or handle. Wipe off any moisture
with a soft cloth.
STORAGE
WARNING
Never store the unit with fuel in the tank and always
allow the unit to cool before storing. Store the unit only
in dry and well ventilated areas.
In case the unit will be stored for an extended time,
use the following storage procedure:
1. Drain all fuel from the fuel tank.
2. Run the engine until it stalls due to lack of fuel.
3. Replace the engine oil with new.
4. Remove the spark plug and put 30 ml of high qual-
ity motor oil into the cylinder. Pull the starter rope
slowly to distribute the oil and then reinstall the
spark plug.
5. Thoroughly clean the unit and inspect for any
loose or damaged parts. Repair or replace dam-
aged parts and tighten loose screws, nuts or bolts.
6. Lubricate all parts required with an oil damp cloth
to avoid rust built-up.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as waste.
Machine, accessories and packaging should be sort-
ed for environment friendly recycling. The plastic
components are labeled for categorized recycling.
Dispose used motor oil and the containers in a man-
ner that is compatible with the environment. We
suggest you take it in a sealed container to your local
recycling center or service station for reclamation.
Do not throw it in the trash, pour it on the ground, or
pour it down a drain.
WARRANTY
This product is warranted in accordance with the le-
gal / country specific regulations, effective from the
date of purchase by the first user. Damage attribut -
able to normal wear and tear, overload or improper
handling will be excluded from the warranty. In case
of a claim, please send the machine, completely as-
sembled, to your dealer or the official service center.