F.F. Group EPHT 1000 Plus SPS 250, Оригинальное руководство пользователя, Страница: 82 / 100

| English 82 EPHT 1000 PLUS / SPS 250 / SPGT 350 & SPBC 230
TROUBLESHOOTING
Problem Possible cause Solution
43 288
Machine fails to operate
Power turned off Turn power on
Mains socket faulty Use another socket
Extension cable damaged Inspect cable, replace if damaged
Fuse faulty/blown Replace fuse
Thermal cut out Allow tool to cool and try again
Machine functions inter-
mittently
Extension cable damaged
Inspect cable, replace if damaged
Contact Service Agent
Internal wiring of garden product
damaged
Contact Service Agent
Motor runs but blades
remain stationary Multitool-attachment not properly
connected to power unit
Check for correct assembly
Cutting blade hot
Cutting blade blunt Have blade sharpened
Cutting blade has dents Have blade inspected/overhauled
Too much friction, due to lack of
lubricant
Lubricate
43 289
Saw chain dry
No oil in reservoir Refill oil
Oil passage clogged Clean oil passage
Saw chain/guide bar hot
No oil in reservoir Refill oil
Chain tension too high Tension saw chain
Dull saw chain Sharpen saw chain or replace
Pole Pruner rips, vibrates,
does not saw properly
Chain tension too loose Tension saw chain
Dull saw chain Sharpen saw chain or replace
Chain worn out Replace saw chain
Chain teeth are facing in the wrong
direction
Reassemble with chain in correct direction
Too much force applied Reduce force
Saw chain/guide bar hot
No oil in reservoir Refill oil
Vent in oil filler cap clogged Clean oil filler cap
Oil passage clogged Clean oil passage
Chain tension too high Tension saw chain
Dull saw chain Sharpen saw chain or replace
Pole pruner cuts out
when sawing
Chain over tensioned “too tight” Retension chain
Over pressure applied to saw
during cutting
Reduce force applied to saw during cutting
New chain Reduce force applied to saw during cutting
Hard wood Reduce force applied to saw during cutting
Wood is wet Allow tool to cool down and restart
Chain teeth facing wrong way/
direction
Reassemble with chain teeth in correct direction
Over heating of tool Allow tool to cool down and restart