Ezgo SHUTTLE 4, Руководство пользователя и руководство по обслуживанию

Страница: 30 / 64

*$62/,1(32:(5('3(56211(/&$55,(56 *2/)&$5
Page 10
Owner’s Manual and Service Guide
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
Checking the Oil Level
Do not overfill engine. Too much oil
may cause smoking or allow oil to enter
the air filter enclosure.
The oil should be checked with the engine warm. The
vehicle should be on a level surface with the parking
brake engaged. Allow adequate time for oil to drain into
the crankcase before checking.
Remove the dipstick and wipe off the entire area indi-
cated with a lint free cloth (Ref. Fig. 16 on page 10).
Insert the dipstick fully into the dipstick hole and remove.
Examine the level of the oil on the dipstick.
The engine can be operated safely as long as the oil is
within the safe operating range as indicated on the dip-
stick. Do not operate vehicle if oil level is below the
safe area indicated on the dipstick.
Oil should be added to bring the level into the safe oper-
ating range (Ref. Fig. 17 on page 10). Remember that oil
expands as it gets hot. Do not overfill. Check that the
oil
fill cap is firmly in place.
When adding oil between oil changes, do not
mix brands or viscosity grades of oil.
Both the oil dipstick and fill cap must be in place before operat-
ing the engine. Failure to install the dipstick and fill cap will
result in oil becoming contaminated and/or oil being discharged
into the engine compartment.
Changing the Oil
Tool List Qty. Required
Wrench,10 mm ............................................................ 1
Oil drain pan ................................................................ 1
For maximum engine performance and longevity, the
engine oil should be replaced after the first 100 hours of
operation. After the initial oil change, it should be
repeated every 125 hours of operation or semi-annually,
whichever comes first.
The selection of oil is dependent upon the service that
the vehicle will perform (Ref. Fig. 18 on page 10). Most
vehicles require 10W-30 oil, whereas vehicles used at
capacity or near capacity load applications will require
10W-40 oil after a break-in period of 100 hours.
If the vehicle is to be stored over the winter
months, it can be stored with the old oil left in
the engine. The oil should be changed as part of spring mainte-
nance. This will remove any moisture that has accumulated
during storage.
Fig. 15 Shift Cable Adjustment
Fig. 16 Clean Entire Dipstick
NEUTRAL
Factory
Installed
Length
1 3/8" (3.5 cm)
F L
Fig. 17 Check Oil Level on Dipstick
Fig. 18 Oil Viscosity Chart
L F
Maximum oil level
for hot engine
Do not overfill
Fill cold engine
to this point
Safe
Operating Range
Hot Engine
ADD
Low Add oil
Full
-20 0 20 40 60 80 100
-30 -20 -10 0 10 20 30 40
C
F
0
0
10W-30 10W-30
10W-40 10W-40
HEAVY DUTY WORK
LIGHT DUTY WORK
(AIR TEMPERATURE)
10W-30 10W-30