Ezgo SHUTTLE 4, Руководство пользователя и руководство по обслуживанию

Страница: 25 / 64

*$62/,1(32:(5('3(56211(/&$55,(56 *2/)&$5
Page 5
Owner’s Manual and Service Guide
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
Depressing the accelerator pedal releases the combina-
tion service/park brake and the pedal mounted parking
brake (which ever is applicable) and energizes the starter
and ignition circuits which cause the engine to run. The
hand operated park brake must be fully released by
hand in order for the engine to start.
To start the vehicle: Apply the service brake, place the
key in the key switch and turn it to the ‘ON’ position.
Move the direction selector to the direction desired.
Release the parking brake. Slowly depress the accelera-
tor pedal to start the engine. Release the service brake
once the vehicle has started.
When the direction selector is in the reverse
position, a warning signal will sound. This is a
device to indicate that the vehicle is ready to run in reverse.
When the accelerator pedal is released, the ignition cir-
cuit is de-energized and the engine stops. To stop the
vehicle more quickly, depress the service brake pedal.
Cold Starting
Starting a cold engine may require use of the choke.
Depress the accelerator approximately 1" (2.5 cm) or
until the starter just begins to operate. Pull the choke out
as required. Accelerate slowly and push the choke in
completely when the engine runs smoothly.
If the vehicle has been running and the engine does not
start within ten seconds, use the choke.
Do not allow the starter to operate con-
tinuously for more than 30 seconds.
Allow 10 seconds before attempting a second time. If the vehicle
does not start on the third attempt, you should turn the key
switch off, lock the parking brake and determine the cause of the
problem.
STARTING VEHICLE ON A HILL
General
There are three parking brakes available on this series of
vehicles, the combination service/parking brake pedal,
the foot operated pedal and the hand operated handle.
The combination service/park brake and the foot pedal
will release when the accelerator is depressed to start
the engine. The hand operated park brake must be
released by hand. The hand operated park brake must
be fully released, in the lowest position possible, in order
for the engine to start.
When the direction selector is in the reverse
position, a warning signal will sound. This is a
device to indicate the vehicle is ready to run in reverse.
The engine stops when the accelerator pedal is released.
To stop the vehicle more quickly, depress the service
brake pedal.
Vehicle with hand operated park brake
Do not hold vehicle on hill by using
accelerator and engine. This will cause
premature and excessive wear to drive train components.
When starting the gasoline vehicle on a hill, it is impor-
tant to follow the procedure below to prevent excessive
or permanent damage to the drive train. Do not hold vehi-
cle on hill by using accelerator and engine. Leaving drive
train in a stalled condition for more than 3 - 4 seconds will
cause permanent damage to drive train components.
To start the gasoline vehicle on a hill: Place left foot on
the service brake. Place the key in the key switch, and
turn the key to the ‘ON’ position. Move the direction
selector to the direction desired. Place right foot on
accelerator. Fully release park brake. Depress the accel-
erator pedal to start the engine and release the service
brake as the vehicle starts to move.
Vehicle with combination service and park
brake
Do not hold vehicle on hill by using
accelerator and engine. This will cause
premature and excessive wear to drive train components.
When starting the gasoline vehicle on a hill, it is impor-
tant to follow the procedure below to prevent excessive
or permanent damage to the drive train. Do not hold vehi-
cle on hill by using accelerator and engine. Leaving drive
train in a stalled condition for more than 3 - 4 seconds will
cause permanent damage to drive train.
To start the gasoline vehicle on a hill: Place left foot on
the service brake. Place the key in the key switch, and
turn the key to the ‘ON’ position. Move the direction
selector to the direction desired. Place right foot on
accelerator. Release park brake by applying service
brake. Depress the accelerator pedal to start the engine
and release the service brake as the vehicle starts to
move.
Vehicle with foot operated park brake
Do not hold vehicle on hill by using
accelerator and engine. This will cause
premature and excessive wear to drive train components.
When starting the gasoline vehicle on a hill, it is impor-
tant to follow the procedure below to prevent excessive
or permanent damage to the drive train. Do not hold vehi-