Ezgo 605586, Руководство по ремонту и обслуживанию

Страница: 98 / 206

Page H-2
FUEL SYSTEM
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
B
Fig. 2 Fuel System
Choke Operation
Pull the choke knob out to operate the choke (Ref. Fig. 3
on Page H-2). Check that the cable operates smoothly
and that the cable returns when the knob is released.
The motion should be smooth throughout the entire
operating range. If there is any binding or sharp bends,
the choke cable assembly must be replaced.
Do not attempt to lubricate the choke cable. Lubricant tends to
retain dirt on the moving parts which will cause premature
deterioration of the cable.
FUEL SYSTEM COMPONENT SER-
VICE AND REPLACEMENT
Choke Cable and Housing Removal
Tool List Qty. Required
Open end wrench, 1/2" ................................................ 2
Open end wrench, 7/8" ................................................ 1
Phillips screwdriver...................................................... 1
Loosen the screw (9) attaching the carburetor choke
shaft to the inner choke cable (1) (Ref. Fig. 3 on Page H-
2). Remove the nuts (2) securing the outer choke cable
(3) to its bracket.
Fig. 3 Choke Cable Attachment
At the seat panel, remove the nut (4) and lock washer
(5) securing the outer cable to the bezel retaining
bracket (6). Slide the nut, lock washer and bezel retain-
ing bracket over the choke cable. Remove the choke
cable assembly and bezel (7) from the seat panel.
Fuel Tank
Fuel Gauge
Sending Unit
Cap
To
Crankcase
Fuel Pump
Fuel Filter
Fuel Line
Pulse Line
Carburetor
See
AIR CLEANER
Section
36
33
32
34
35
29