Ezgo 605586, Руководство по ремонту и обслуживанию

Страница: 164 / 206

Page P-2
REAR AXLE
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
B
Handle all gears with extreme care since each is part of a
matched set.Damage to one will require replacement of
the entire set or result in an unacceptably high noise level.
Snap rings must be removed/installed with care to pre-
vent damage of bearings, seals and bearing bores.
It is recommended that whenever a bearing, seal or ‘O’ ring is
removed, it be replaced with a new one regardless of mileage.
Always wipe the seals and ‘O’ rings with a light oil before
installing.
To reduce the possibility of personal injury, fol-
low the lifting procedure in SAFETY section of
this manual. Place wheel chocks in front and
behind the front wheels and check the stability
of the vehicle on the jack stands before starting
any repair procedure. Never work on a vehicle
that is supported by a jack alone.
Axle Shaft Removal and Disassembly
Tool List Qty. Required
Arbor press ..................................................................1
Bearing separator ........................................................1
Needle nose pliers .......................................................1
Internal snap ring pliers................................................1
Slide hammer, P/N 18753-G1 ......................................1
For brake drum removal, see BRAKES section.
Remove the outer snap ring from the axle tube (Ref. Fig.
3 on Page P-2).
Fig. 3 Removing/Installing Outer Snap Ring
Attach a slide hammer to the axle shaft thread and
remove the axle and bearing from the axle tube (Ref.
Fig. 4 on Page P-2).
Fig. 4 Removing/Installing Axle Shaft
Remove the bearing by supporting the inner race of the
bearing on an arbor press bed and apply pressure to the
threaded end of the axle shaft (Ref. Fig. 5 on Page P-2).
Fig. 5 Pressing Bearing from Axle Shaft
Axle Shaft Seal Removal and Replacement
Tools List Qty. Required
Internal snap ring pliers............................................... 1
Seal puller ................................................................... 1
Plastic faced hammer.................................................. 1
Ratchet, 3/8" drive....................................................... 1
Torque wrench, 3/8" drive, ft. lbs. ................................ 1
Socket, 17mm, 3/8" drive ............................................ 1
Using snap ring pliers, remove bearing retaining ring (1)
from the end of axle tube (2). (Ref. Fig. 6 on Page P-3).
Carefully pull axle shaft (3) and bearing out of the tube.
Using a 17 mm socket, remove the hardware (4) attach-
ing the axle tube to the casing and carefully lift the tube
from the casing studs.
Using seal puller, remove axle shaft seal (5) from casi-
ing.
Bearing
Separator