Ezgo 28806-G01, Руководство пользователя и руководство по обслуживанию

Страница: 39 / 70

OPERATION AND SERVICE INFORMATION
Page 23
Owner’s Manual and Service Guide
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
correctly installed. Insert cover into the lower portion of
the enclosure and swing it up into place. Squeeze hous-
ing together and secure with top clips. Be sure cover fits
under tabs and all clips are fastened securely.
Cleaning the Air Filter Element
Do not use compressed air to clean the
air filter; doing so will damage the filter
which may result in damage to the engine.
If the element is in acceptable condition, loose dirt may
be removed by tapping the filter lightly. Do not use oil on
the filter element or any part of the unit.
Canister Type Air Cleaner
The air cleaner element is accessible by unsnapping the
clips on the air canister and removing the cover and air
filter element (Ref. Fig. 39 on page 23). Clean inside of
cover, canister and dust collector. Install the element and
cover the same way they were removed. Be sure the
positioning arrow on cover is pointing upward and all
clips are fastened securely.
Cleaning the Air Filter Element
Do not use compressed air to clean the
air filter; doing so will damage the filter
which may result in damage to the engine.
If the element is in acceptable condition, loose dirt may
be removed by tapping the filter lightly. Do not use oil on
the filter element or any part of the unit. Install the ele-
ment in the same way it was removed, being sure that
the clips are fastened securely.
LUBRICATION
Do not use more than three (3) pumps
of grease in any grease fitting at any
one time. Excess grease may cause grease seals to fail or
grease migration into areas that could damage components.
Putting more than three pumps of grease in a grease fit-
ting could damage grease seals and cause premature
bearing failure (Ref. Fig. 40 on page 23).
SPARK PLUGS
Tool List Qty. Required
Spark plug socket, 13/16", 1/2" drive........................... 1
Ratchet, 1/2" drive ....................................................... 1
Plug gauge, wire type.................................................. 1
Anti-seize compound................................................ AR
Torque wrench, 1/2" drive, ft. lbs. ................................ 1
Use care not to over-tighten the plug.
Over-tightening can cause damage to
the aluminum cylinder head threads.
Fig. 38 Air Cleaner
Ref Air 1
Front and back sides
of tabs may be
lubricated with
petroleum jelly
Front and back sides
of air filter seal may
be lubricated with
petroleum jelly
Fig. 39 Canister Type Air Cleaner
Fig. 40 Lubrication Points
Dust
Collector
Air Cleaner
Cover
Air Cleaner
Canister
Air Filter
Element
Ref Air 2
View From Underside Of Vehicle
Rack Ball Joint
Ref Lub 1