Ezgo 28806-G01, Руководство пользователя и руководство по обслуживанию

Страница: 25 / 70

OPERATION AND SERVICE INFORMATION
Page 9
Owner’s Manual and Service Guide
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
VEHICLE CLEANING AND CARE
VEHICLE CLEANING
To reduce the possibility
of severe injury or vehi-
cle damage, read and
understand all instructions supplied by manufacturer
of pressure washer.
When pressure washing exterior of
vehicle, do not use pressure in excess
of 700 psi. To reduce the possibility of cosmetic damage, do not
use any abrasive or reactive solvents to clean plastic parts.
It is important that proper techniques and cleaning mate-
rials be used. Using excessive water pressure may
cause severe injury to operator or bystander, damage to
seals, plastics, seat material, body finish or electrical sys-
tem. Do not use pressure in excess of 700 psi to wash
exterior of vehicle.
Clean windshield with lots of water and a clean cloth.
Minor scratches may be removed using a commercial
plastic polish or Plexus
®
plastic cleaner available from
the service parts department.
Normal cleaning of vinyl seats and plastic or rubber trim
requires the use of a mild soap solution applied with a
sponge or soft brush and wipe with a damp cloth.
Removal of oil, tar, asphalt, shoe polish, etc. will require
the use of a commercially available vinyl/rubber cleaner.
The painted surfaces of the vehicle provide attractive
appearance and durable protection. Frequent washing
with lukewarm or cold water and mild detergent is
required to preserve the painted surfaces.
Occasional cleaning and waxing with non-abrasive prod-
ucts designed for ‘clear coat’ automotive finishes will
enhance the appearance and durability of the painted
surfaces.
Corrosive materials used as fertilizers or for dust control
can collect on the underbody of the vehicle. These mate-
rials will cause corrosion of underbody parts unless
flushed occasionally with plain water. Thoroughly clean
any areas where mud or other debris can collect. Sedi-
ment packed in closed areas should be loosened to ease
it’s removal, taking care not to chip or otherwise damage
paint.
If the engine does not start or runs improperly
after washing, remove the spark plug wires (by
pulling the spark plug boots, never the wires). Dry all connec-
tions with forced air. Reinstall the wires.
! !