Ezgo 28806-G01, Руководство пользователя и руководство по обслуживанию

Страница: 26 / 70

OPERATION AND SERVICE INFORMATION
Page 10
Owner’s Manual and Service Guide
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
REPAIR
LIFTING THE VEHICLE
Tool List Qty. Required
Floor jack..................................................................... 1
Jack stands ................................................................. 4
Chocks ........................................................................ 4
Some servicing operations may require the front wheels,
the rear wheels, or the entire vehicle be raised.
To reduce the possibility
of severe injury or death
from a vehicle falling
from a jack:
Be sure the vehicle is on a firm and level surface.
Never get under a vehicle while it is supported by
a jack.
Use jack stands and test the stability of the vehi-
cle on the stands.
Always place chocks in front and behind the
wheels not being raised.
Use extreme care since the vehicle is extremely
unstable during the lifting process.
When lifting vehicle, position jacks and
jack stands at the areas indicated only.
To raise the entire vehicle, install chocks in front and
behind each front wheel (Ref. Fig. 16 on page 10). Cen-
ter the jack under the rear frame crossmember. Raise the
vehicle enough to place a jack stand under the outer
ends of the rear axle.
Lower the jack and test the stability of the vehicle on the
two jack stands.
Place the jack at the center of the front axle. Raise the
vehicle enough to place jack stands under the frame
crossmember as indicated.
Lower the jack and test the stability of the vehicle on all
four jack stands.
If only the front or rear of the vehicle is to be raised, place
the chocks in front and behind each wheel not being
raised to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
WHEELS AND TIRES
Tire Repair
Tool List Qty. Required
Lug wrench, 3/4".......................................................... 1
Impact socket, 3/4", 1/2" drive ..................................... 1
Impact wrench, 1/2" drive ............................................ 1
Torque wrench, 1/2" drive ............................................ 1
A t i r e e x p l o s i o n c a n
cause severe injury or
d e a t h . N e v e r e x c e e d
inflation pressure rating on tire sidewall.
To reduce the possibility of tire explosion, pres-
surize tire with small amount of air applied inter-
mittently to seat beads. Due to the low volume of
the small tires, overinflation can occur in sec-
onds. Never exceed the tire manufacturer’s rec-
ommendation when seating a bead. Protect face
and eyes from escaping air when removing valve
core.
To reduce the possibility of severe injury caused
by a broken socket when removing wheels, use
only sockets designed for impact wrench use.
! !
Fig. 16 Lifting the Vehicle
Ref Liv 1 View from Underside of Vehicle
Center of
Front Axle
Flat Portion
of Frame
Outside End
of Rear Axle
! !