Page | 4
3.
PACKAGE CONTENTS, CONT’D.
2
LOWER END LOOP
Shown with O-ring and Attachment Screw
(If handrails were purchased)
4
SCREW
1/4” Self-drilling, Self-t
apping Hex Washer Head
(If handrails were purchased)
4
O-ring
(If handrails were purchased)
1
INSTRUCTIONS
4.
AVAILABLE RAMP LENGTHS AND STYLES
4.1
The ramp is available in 3-, 4-, 5-, 6-, 7-, 8-, 9-, and 10-ft. lengths and comes with a self-adjusting lower
transition plate and a fixed top lip transition plate.
Ramp lengths of 3-ft. through 8-ft. have 2-in. curbs; the 9-ft. and 10-ft. lengths have 4-in. curbs.
4.2
Shown below is the 6-ft. ramp without handrails (FIG. 1), the 6-ft. ramp with two-line handrails (FIG. 2),
and the 6-ft. ramp with vertical picket handrails (FIG. 3).
FIG. 1
FIG. 2
FIG. 3
5.
CARE AND MAINTENANCE
5.1
Before each use, check the ramp for worn or damaged parts. If you find any of these conditions, do not
use the ramp.
Do not tamper with, attempt to repair, or modify any portion of the ramp.
5.2
Before each use, tighten any loose fasteners.
5.3
Keep the ramp surface clear of ice, snow, dirt, leaves, and other debris. For ice and or snow, remove all
accumulations and sweep surface clean. For dirt, leaves, and other debris, sweep surface or wash with a
soft bristle brush and non-alkaline detergent, rinse well.
The ramp surface may be slippery in wet conditions. Use caution if surface is wet as traction may
be reduced.
5.4
Store the ramp in a cool, dry place when not in use.
