Extron electronics TPS150, Руководство пользователя

Страница: 35 / 52

4-9 TPS150 Switching and Transmission System • Serial Communications
3 . Repeat step 2 for each button or code to be programmed.
4 . Click in the upper right corner of the window to close the window.
5 . Click Controls > Projector Codes > Projector Delay. The program projector delay
window appears (figure 4-13).
Figure 4-13 — Program projector delay window
When you open the window, the ICS 100 automatically resets the projector
delay in the transmitter to 0 seconds and displays 000 in the variable window.
6 . For the power on (warm-up) delay (0 to 60 seconds) and power off
(cool-down) delay (0 to 256 seconds), click and drag the slider or click the
scroll left ( ) or scroll right ( ) button until the desired interval (in seconds)
appears in the variable window.
The ICS100 program automatically sends the revised projector delay to the
transmitter as soon as you move the slider.
If you click the Projector On or Projector Off button, the Projector Power
LED on the transmitter’s front panel blinks while the delay times out. All
front panel operations are disabled during the delay.
7 . Click in the upper right corner of the window to close the window.
8 . If no further operations are to be performed, halt communication with the
switcher by selecting a different address. See Establishing communications with
the program, step 12.
Using the software to operate the transmission system
Use the control program to operate the transmitter as follows:
1 . Click Controls > Control Panel. The transmitter control panel window appears
(figure 4-14).
Figure 4-14 — Transmitter control panel window