5
Connecting the TLP 710CV
NOTE:
The rest of this guide applies only to the TLP 710CV (not to the TLE 710).
The cable connections are located in a panel on the bottom of the TLP 710CV:
POWER
12V
1.0A MAX
LAN / PoE
MTP
c b a
Step 9 — Connect the MTP Input
Connect the output of an Extron Mini Twisted Pair (MTP) transmitter to the MTP socket (
a
) on the TLP 710CV. This signal
provides composite or S-video and audio input.
ATTENTION:
Ensure the MTP transmitter is connected to the MTP socket (
a
, in the figure above). Both the MTP
connector and the LAN and PoE connector use RJ-45 connectors, but the wires on each connector use different voltages.
Inputting the wrong voltages into a socket will damage the TLP 710CV.
Step 10 — Connect the Network and Power Over Ethernet Connector
Extron strongly recommends using a Power over Ethernet (PoE) power supply, although a 12 VDC, 1.0 A power supply (not
provided) can be used instead (see below).
ATTENTION:
•
Before connecting the PoE connector (
b
), read the cautions listed in the “Network and Power over Ethernet
Connector” section of the TLP 710CV User Guide, which is available at www.extron.com.
•
Ensure the network connector is connected to the network socket (b). Both the MTP connector and the LAN and PoE
connector use RJ-45 connectors, but the wires on each connector use different voltages. Inputting the wrong voltages
into a socket will damage the TLP 710CV.
Connecting to the Network Directly (Using an external 12 VDC Power Supply)
If the PoE power supply is not used, run a straight-through cable from the LAN/PoE connection (
b
) to a network switch or router.
Connecting to a Power over Ethernet Power Supply
1.
Use a straight-through LAN cable to connect the LAN-IN socket to a
network switch or router.
2.
Use a second straight-through LAN cable to connect the PWR LAN-OUT
socket to the LAN/PoE connector (
b
) on the TLP 710CV. This cable carries
network information and 48 VDC.
3.
Connect the IEC power cord from the power supply to a convenient
100 VAC to 240 VAC, 50-60 Hz power source.
Step 11 — Connect the External Power Supply (Optional)
CAUTION:
Before connecting the power supply, read the cautions listed in the “Power Connector” section of the
TLP 710CV User Guide
, which is available at
www.extron.com
.
Extron strongly recommends using PoE to provide power to the TLP 710CV. To use a 12 VDC, 1.0 A
power supply (not provided), connect the two pole, 3.5 mm captive screw connector from the power
supply (part number
70-775-01
) to the power supply socket on the rear panel (
c
).
NOTE:
For advice about using captive screw connections, see the notes in the “Power
Connector” section of the
TLP 710CV User Guide
, which is available at
www.extron.com
.
Power over Ethernet (PoE) Power Supply
PWR LAN-OUT
LAN-IN
To Network Switch
To TLP 710CV
a
MTP connector
b
LAN and PoE connector
c
External power supply connector
-
POWER
12
V
1.0A MAX
3/16"
(5 mm) Max.
