8
SF 8CT SUB Subwoofer • Setup Guide (Continued)
Mounting the Speaker
Suspended Ceiling Mounting
The speaker can be installed into rigid material (mineral tile, gypsum board, sheetrock, etc.) or soft material, such as fiberglass.
1.
Insert the speaker through the bottom of the hole in the ceiling tile that was cut in
(“
”) with the wires out of the way.
2.
Clamp the speaker to the C-ring by using a Phillips screwdriver to tighten the four locking arms to the C-ring (see figure 9).
Figure 10.
Clamping the speaker to the C-ring
Tightening the locking arms into rigid material:
For rigid material use the Opti-Torque
TM
indicator ring as a tightening guide.
NOTE:
Each of the four locking arm screws uses an Opti-Torque
TM
indicator ring. The indicator releases a red plastic ring
onto the screwdriver once the screw is tightened to the correct torque. Stop tightening any further when this occurs to
avoid overtightening the locking arms to the C-ring.
Figure 11.
Stop tightening when the red ring falls
ATTENTION:
•
To avoid damaging the speaker locking arms, do not overtighten the four screws.
•
Ne pas trop serrer les quatre vis pour éviter d’endommager les bras de verrouillage de l’enceinte.
