Extron electronics Quantum Ultra 305, Руководство пользователя, Страница: 35 / 111

Quantum Ultra Videowall Processing System • Installation and Configuration 27
• DTP output cards (Quantum Ultra 610 and 305 only) — These cards have four
twisted pair outputs on RJ-45 connectors. They also contain an RS-232/IR control
connector for each output, a TP mode switch, and a power connector providing
power over DTP for the four outputs.
2 2 2 3 3 3
1 1 1
OU
T
HDB
T
SIG LINK
4A MAX
DTP POWER
12V
SIG LINK QUANTUM OUT4DTP
OUT
TxRx Rx G Tx
OUT
TxRx Rx G Tx TxRx Rx G Tx TxRx Rx G Tx
SIG LINK
OUT
SIG LINK
OUT
DTP
4 4 4
OUTPUTS
1
DTP output connectors
3
OVER TP control connectors
2
TP mode switch
4
DTP POWER connector
Figure 23. DTP Output Card
1
DTP output connectors — Connect STP cables between these connectors
(labeled OUT) and up to four compatible Extron DTP receivers, XTP matrix
switcher inputs, or third-party HDBaseT-enabled sink devices.
2
TP mode switch — This three-position switch enables you to select between
the following twisted pair output modes:
• DTP mode — Passes video signals, and allows bidirectional RS-232 and IR
control between the DTP output card and DTP receivers via the OVER TP
control connectors (see figure 23,
3
).
Remote power over DTP is available via the 2-pole DTP POWER connector
(
4
).
•
XTP mode — Passes video signals, and allows bidirectional RS-232 and IR
control between the DTP output card and XTP matrix switcher inputs via the
OVER TP control connectors (
3
). Remote power is not supported.
• HDBT mode — Passes video signals, and allows bidirectional RS-232 and
IR control between the DTP output card and HDBT sink devices via the
OVER TP control connectors (
3
) Remote power is not supported.
23