Extron electronics NBP 1200C, Руководство по установке

Страница: 14 / 14

14
NBP 1200C • Setup Guide (Continued)
© 2019 Extron Electronics All rights reserved. www.extron.com
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters:
Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
68-3267-5 3 , Rev. A
12 19
Overall Configuration Procedure
Configure the IP settings of each NBP
and of the control processor or receiver.
See the network
communication
setup instructions
Create a new GC Professional or GC Plus project
and add the control processor or receiver to it.
Configure ports.
Add NBP button panels and configure the buttons.
Test the system, make adjustments,
finalize configuration.
Save the project.
Cable the NBPs and the control processor or HCR receiver,
then apply power.
Cable all devices.
Prepare the installation site.
Get ready.
Change buttons or faceplates, if desired
Mount the NBPs.
Create monitors, schedules, timers, macros,
and local variables.
Build and upload the configuration to
the controller or receiver.
If desired or required, install a new
security certificate (via Toolbelt).
Within Global Configurator
(GC Professional or
GC Plus mode):
Figure 15. Overall Configuration Steps
network
communication
setup instructions
on page 10.
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide on the Extron website.