Extron electronics NBP 1200C, Руководство по установке

Страница: 11 / 14

11
Front Panel Features
e
ON
OFF
LAPTOP
PC
MUTE
MEDIA PLA
YER
HDMI 1
HDMI 2
A A A A A
H H H H H
B B B B B
E E E E E
D D D D D
G G G G
H H H H H
C C C C C
I I I I I
Figure 14. NBP 1200C Front Panel
A
Function buttons — Configure these buttons to light and function as desired.
B
Power buttons
— These buttons (labelled “On” and “Off”) are usually used to control the power to the display device. The
On
button has a nub that can be felt with fingertips.
C
Communications LED — This LED indicates the configuration and connection status of the NBP.
•
Unlit — Normal operation (the NBP is configured and connected to an IPCP Pro control processor).
•
Blinking red — The NBP has been configured but is not connected to an IPCP Pro control processor.
•
Lit steadily — The NBP has not been configured.
D
Volume buttons
— Configure
Volume
buttons to increment or decrement audio volume.
E
Volume LEDs — Volume LEDs light to act as a meter to indicate the volume level.
NOTE:
There is no item
F
for this NBP model.
G
Cable Cubby lid — The lid tilts back to 130°. Friction washers ensure the lid holds any angle set by the user. A switch in
the hinge activates the buttons when the lid is fully open and deactivates them when the lid is closed to prevent accidental
button presses.
H
Button panel removal slots
— Use the Extron removal tool in these slots to release the top of the panel when replacing buttons.
I
Button panel hinge — Holds the bottom of the panel in place, allowing the panel to tilt forward when replacing buttons.
All the function, power, and volume buttons must be configured or programmed to carry out their functions. The buttons are
backlit by LEDs.
In addition to the visible features, the NBP has a buzzer located on a circuit board within the front panel. The behavior of the
buzzer can be configured using Global Configurator or programmed with Global Scripter to be globally disabled or to beep as
desired when a button is pressed.