
NAV SD 511 Scaling Decoder • Installation
10
Analog audio connectors
See figure 5 to wire a connector for the appropriate output type. Connectors are included
with the decoder, but you must supply the audio cable. Use the supplied tie-wrap to strap
the cable to the extended tail of the connector.
Unbalanced Stereo Output
Balanced Stereo Output
Do not tin the wires!
Tip
No Ground Here
No Ground Here
Tip
LR
Sleeves
Tip
Ring
Tip
Ring
LR
Sleeves
Figure 5.
Captive Screw Connector Wiring for Audio Outputs
ATTENTION
:
•
For unbalanced audio, connect the sleeves to the ground contact.
DO NOT
connect the sleeves to the negative (-) contacts.
•
Pour l’audio asymétrique, connectez les manchons au contact au sol.
NE PAS
connecter les manchons aux contacts négatifs (–).
NOTES:
•
The length of exposed wires is important. The ideal length is 3/16 inch (5 mm).
•
If the stripped section of wire is longer than 3/16 inch, the exposed wires may
touch, causing a short circuit.
•
If the stripped section of wire is shorter than 3/16 inch, wires can be easily pulled
out even if tightly fastened by the captive screws.
•
Do not tin the wires before installing them in the connector. Tinned wires are not as
secure in the connector and could be pulled out.
A balanced stereo audio connector consists of a tip, ring, and
Sleeve ( )
Ring (-)
Tip (+)
3.5 mm Stereo Plug Connector
(balanced)
sleeve. An unbalanced mono audio connector consists of a tip
and sleeve. When you are making connections for the units
from existing audio cables, see the drawing at right to identify
the tip, ring, and sleeve parts of the connector. The ring, tip,
and sleeve wires are also shown on the captive screw audio
connector diagram, figure 5.
Control connector wiring
Figure 6 shows how to wire the Control (RS-232 and IR) connector.
G
S
Rx
Tx
Gnd
IR Device
RS-232 Device
RS-232
Tx
Rx
GS
G
IR
CONTROL
Figure 6.
Control Connector Wiring
NOTES:
•
The RS-232 Tx and Rx line pair must cross once between this connector and the
destination.
•
The length and preparation of exposed wires is important (see the audio connector
above for details).
Содержание NAV SD 511
Страница 1: ...User Guide NAV Pro AV Over IP 68 3606 01 Rev A 08 22 NAV SD 511 Streaming HDMI Scaling Decoder...
Страница 6: ......
Страница 8: ...NAV SD 511 Scaling Decoder Contents viii...