MGP Pro Series • Operation
29
Making changes to the serial port and IP configuration
To make changes to the serial port configuration, IP address, DHCP mode, gateway
address, and subnet mask, access the edit level screens as follows:
1.
With any Comm./IP Configuration menu view-level screen displayed, press the Enter
button and hold it until the Serial Config screen appears (approximately 2 seconds).
2.
Press Next repeatedly to cycle through the edit level screens.
3.
To enter or change information on each screen, rotate the horizontal Adjust knob (
[
)
to move the angle brackets to the desired setting. Rotate the vertical Adjust knob (
{
) to
adjust the setting.
4.
When finished editing the settings for the selected item, either press Next display the
editing screen for the next item, or press Menu to exit serial and IP edit mode and
display the next menu (Advanced Configuration).
The following screens are provided for editing parameters:
•
Serial
Config:
Configure the serial port by switching between RS-232 and RS-422,
and selecting the baud rate.
•
Set
DHCP
Mode:
Set DHCP to On or Off.
NOTE:
DHCP must be off before you can edit the IP addresses.
•
Set
IP
Address:
Set the IP address.
•
Set
Gateway
Addr:
Set the gateway address.
•
Set
Subnet
Mask:
Set the subnet mask.
NOTE:
The MAC address has no screen in this mode because it cannot be edited.
Figure 20.
Communication/IP Configuration Menu Flow