Extron electronics DSC HD-HD 4K Plus A Series, Руководство пользователя, Страница: 44 / 92

The
Communications
submenu contains the following items (see figure 30 on the
previous page):
• Serial Port — (View only) Displays the port type (RS-232) and the baud rate. The
protocols for this port is 9600 baud, eight data bits, no stop bits, and no parity.
• MAC Address — (View only) Displays the media access code (hardware address) of
the unit. This address is hard-coded at the factory and cannot be changed.
•
DHCP Mode — When this mode is enabled (
On
), the unit configures its IP address
and other network settings from the DHCP server. The default is
Off
.
To enable or disable DHCP mode:
1. Select
DHCP Mode
from the
Communications
submenu and press
Enter
.
2. Press the

or

button to select
On
or
Off
and press
Enter
again.
You can also set the DHCP mode via SIS commands (see the DHCP mode
commands on page 66), the PCS software, or the DSC HD-HD 4K Plus A series
website.
• IP Address — Lets you set the IP address for the unit. The default address is
192.168.254.254
.
• Subnet Mask — Lets you set the subnet mask for the unit. The default subnet mask
is
255.255.0.0
.
• Gateway — Lets you set the gateway address for the unit. The default gateway
address is
0.0.0.0
.
Setting the IP, subnet mask, and gateway addresses
To set the IP address, subnet mask, or gateway address:
1. Select the item to be changed from the
Communications
submenu and press
Enter
.
2. Press the
t
and

buttons to move the yellow selection arrows and highlighting to the octet
to be changed and press Enter .
3.
Press the

or

buttons to select the desired value for the octet, then press
Enter
.
4. To rapidly increase or decrease the octet value, press and hold the

or

button
until the desired value is displayed.
5. Repeat step 2 for the next octet to be changed, or press
Enter
again to return to the
submenu level.
DSC HD-HD 4K Plus A Series • Operation 36