2
ACP 106 EU/MK • Setup Guide (Continued)
Step 2: Prepare the Installation Site
ATTENTION:
•
Installation and service must be performed by authorized personnel only.
•
L’installation et l’entretien doivent être effectués par le personnel autorisé uniquement.
•
Extron recommends installing the ACP 106 EU/MK into a grounded, UL Listed electrical junction box.
•
Extron recommande d’installer le ACP 106 EU/MK dans un boîtier d’encastrement électrique mis à la terre, listé UL.
•
If the ACP 106 EU/MK will be installed into fine furniture, it is best to hire a licensed, bonded craftsperson to cut the
access hole and perform the physical installation so the surface will not be damaged.
•
S’il est prévu d’installer le ACP 106 EU/MK dans du beau mobilier, il est préférable de faire appel à un artisan autorisé et
qualifié pour couper le trou d’accès et réaliser l’installation de telle façon que la surface ne soit pas endommagée.
•
Follow all national and local building and electrical codes that apply to the installation site.
•
Respectez tous les codes électriques et du bâtiment, nationaux et locaux, qui s’appliquent au site de l’installation.
NOTE:
For the installation to meet UL requirements and to comply with National Electrical Code (NEC), the ACP 106 EU/MK
must be installed in a UL Listed junction box. The end user or installer must furnish the junction box. It is not included with
the ACP 106 D.
Americans with Disabilities ACT (ADA) Compliance
When planning where to install these devices, consider factors affecting accessibility of the button panel such as height
from the floor, distance from obstructions, and how far a user must reach to press the buttons. For guidelines, see sections
307 (“Protruding Objects”) and 308 (“Reach Ranges”) of the
2010 ADA Standards for Accessible Design
available at
http://www.ada.gov/regs2010/2010ADAStandards/2010ADAStandards.pdf
.
Site Preparation
Extron offers an assortment of mud rings, optional UL Listed in-wall junction boxes, external wall boxes (EWBs), and surface or
tabletop mounting boxes for use with the ACP button panels. The ACP 106 EU and ACP 106 MK are 1-gang EU and MK size
devices.
Step 3: Removing the Plastic Faceplate, Button Panel, and Changing
the Buttons
The plastic faceplate and buttons can be replaced. Additional buttons ship with the device and
others can be ordered from
.
To change the buttons:
1.
Insert the Extron removal tool (pry tool) between one side of the plastic faceplate and the
button plate. Release the catch holding the wallplate to the metal mounting plate (see
1
in the figure to the right). If necessary, use the pry tool to release the second catch on the
opposite side.
2.
To separate the button plate from the control plate, insert a small flat-bladed screw driver
into one of the slots (see
2
in the figure at the bottom of the page).
3.
Press the blade of the screw driver in until there is an audible
click and the tab is pushed out of the slot.
4.
Repeat steps 2 and 3 to release all four tabs holding the button
plate in place.
5.
Tilt the top of the button plate forward as it is removed to
prevent the buttons from falling out (
3
).
VOLUME
MUTE
2
2
3
3
X
MIC
PROG
RA
M
VOLUME
MUTE
PC
MIC
PR
OGRAM
X
Extr
on
Extr
on
Insert
to line.
1
1