Monitoring the Ethernet Interface
By RJ45 Ethernet: See the figures in
Industrial Series Switch Overview
on page 9 for monitoring 8
Gigabit Ethernet with copper connector (RJ45). Also refer to
on page 12 for the normal
operational LED status.
By SFP: See the figures in
Industrial Series Switch Overview
on page 9 for monitoring 4 Gigabit
Ethernet with SFP connector. Also refer to
on page 12 for the normal operational LED status.
Upgrading and Downgrading Software
1. From the web UI, go to
Maintenance
> >
Software
> >
Upload
page.
2. Select the software file, and click
Upload
.
3. After beginning the upload process, do not cold/warm start device. Instead, wait for auto-reboot,
and then the upgrade can complete.
Resetting Configuration Defaults via CLI Command
If you want to reset the configuration to default, but keep management IP settings, do the following:
1. Execute the command:
reload defaults keep-ip
2. Check interface
and IP address, and confirm only management IP setting is kept.
3. Execute the command:
copy running-config startup-config
If you want to reset all configurations to the default:
4. Execute the command: reload defaults
5. Check interface VLAN and IP address, and confirm they all change to default settings.
Installing Industrial Switches
Monitoring the Ethernet Interface
ISW Series Managed Industrial Ethernet Switch Hardware Installation & User Guide
27
